Jl audio 300/4 amplifier manual

/4v34 Ch. Class A/B Full-Range Amplifier, W. $ Save $ $ Buy in monthly payments with Affirm on orders over $ Learn more. star rating. 6 www.doorway.rug Factor @ 4 Ω: / 50 Hz.  · My /4 bridged to my front comps just keeps up with my /1 to 2 10w1's. Your /1 to 3 10w3's should be hard to keep up with. You should have someone hook up a system like that if youve never done one before. Disconnect the speaker (s) from the amplifier. Turn off all processing on the source unit and the amplifier (bass/treble, loudness, EQ, etc.). Turn the input sensitivity control on the amplifier all the way down. If there is a sensitivity range switch, set it to the “low” position. Set the source unit volume to .

Discontinued Mobile Amplifier Owner's Manuals. In this section, you will find technical information for amplifiers that are no longer current in JL AUDIO's lineup. The amplifiers are listed below by model number. Choose an amplifier below to Download an Owner's Manual for that model (Adobe Reader Required). Slash Amplifiers. If the amp only goes into protect when one particular speaker is connected to the amp, you have a defective speaker.. Step 4. If the amplifier goes into protect with the RCAs plugged in (but all speaker wires disconnected), there could be several problems. You first need to check the RCA shields of the head unit. Use the links below to navigate to the owner's manual or product page for each of the listed Mobile amplifiers: VXi Amplifiers. VX/1i. Owner's Manual. Product Page. VX/5i. Owner's Manual. Product Page. VX/8i.

Use the links below to navigate to the owner's manual or product page for each of the listed Marine amplifiers: MVi Amplifiers. MV/5i. Owner's Manual. Product Page. MV/1. Owner's Manual. Product Page. Disconnect the speaker (s) from the amplifier. Turn off all processing on the source unit and the amplifier (bass/treble, loudness, EQ, etc.). Turn the input sensitivity control on the amplifier all the way down. If there is a sensitivity range switch, set it to the “low” position. Set the source unit volume to 3/4 of full volume. Note: Amplifier depicted is for reference only - check the capability of your amplifier before making any connections. One DVC driver with Voice Coils in Series. One Dual Voice Coil Speaker in Series. Connecting the two voice coils of the driver in series (+ to -) will result in the following impedances: Dual–8 Ohm Subwoofer: 16 Ohms.